Replacing the Supercap Power Module (RAID Backup Battery).Replacing a Modular RAID Controller Transportable Memory Module (TMM).Replacing a Cisco Modular RAID Controller Card.This appendix contains the following sections:Īlso see these procedures for replacing RAID-related hardware: Restoring RAID Configuration After Replacing a RAID Controller.
#Drives all listed as lsi megasr drivers#
Installing LSI MegaSR Drivers For Windows and Linux.Launching the LSI Embedded MegaRAID Configuration Utilities.Disabling the Embedded RAID Controller in the BIOS.Enabling SATA Mode and Selecting Option ROM Mode.Enabling the Embedded RAID Controller in the BIOS.Installing a Software RAID 5 Key Module for Embedded RAID 5 Support.Installing a SATA Interposer Board For Front-Facing Drive Control.Embedded SATA RAID Controller Considerations.Embedded SATA RAID: Two SATA Controllers.Embedded SATA RAID Controller Requirements For Front-Facing Drive Control.SFF 24-Drive Backplane with Expander Cabling.SFF 16-Drive Backplane with Integrated Expander.SFF 8-Drive Direct-Connect Backplane, No Expander.Cisco UCS C240 M4 Server RAID Controller Cabling Instructions.Setting the Preferred Boot Device for Cisco UCS 9300-8e.Cisco UCS 9300-8e Bad Drive and Predictive Failure Behavior.Optical Cables Not Supported for 9300-8e HBA.Cisco UCS SAS 9300-8e HBA Considerations.Support Matrix For Cisco UCS C240 M4 Server RAID Controllers.Write-Cache Policy for Cisco 12G SAS Modular RAID Controller.Stripe-Size Limitation When No Flash-Backed Write Cache is Present.